[. . . ] Gateway 2000 may improve and/or change products described in this publication at any time. Due to continuing system improvements, Gateway 2000 is not responsible for inaccurate information which may appear in this manual. For the latest product updates, consult the Gateway 2000 web site at www. gateway. com. In no event will Gateway 2000 be liable for direct, indirect, special, exemplary, incidental, or consequential damages resulting from any defect or omission in this manual, even if advised of the possibility of such damages. [. . . ] (Only required if Windows 95 has been reinstalled) Click OK to confirm that you want to remove the unknown device. Next, scroll down the list of devices and click the + next to Sound, video and game controllers. Click the Driver tab in the ESS ES1688 AudioDrive Properties dialog box. The Update Device Driver Wizard appears asking if you want Windows to search for the driver. Click OK. Chapter 4: Installing Drivers and Related Software 35 Click Yes to restart your computer. If you are reinstalling the Windows 95 operating system and need to install additional drivers, you can click No to restart the computer. Continue installing the other drivers before restarting. Enabling the software wavetable 1. On Device Manager tab click the + next to Sound, video and game controllers. Click the Enable check box under ESS Software Wavetable. Enabling ESS Software Wavetable 6. Click OK to close the properties box, then click OK to close System Properties. 36 Maintaining and Troubleshooting Your Solo Notebook Windows 95 EZ Pad Plus (touchpad) drivers Use the following instructions to install the Windows 95 touchpad driver that supports your touchpad. If the Solo System CD shipped with your system, you may use it to install the driver instead of installing the drivers from diskette. Installing the touchpad Driver 1. Wait a few seconds for the Update Device Driver Wizard to find the drivers. When Windows restarts, the Copying Files dialog box appears and displays a message that it is looking for file uhcd. sys. Redirect the path by typing: C:\Windows\System Click OK. Redirecting the path in the Copying Files dialog box 13. Click Yes to continue. 42 Maintaining and Troubleshooting Your Solo Notebook 15. When completed, the correct USB driver appears in the Device Manager as shown below. Properly installed USB drivers shown in the Device Manager Installing software updates Install the following software updates to complete the system install. Installing the UHCD. SYS update 1. Click Yes to continue with the installation. Chapter 4: Installing Drivers and Related Software 43 4. to initialize the supplement. 44 Maintaining and Troubleshooting Your Solo Notebook Installing for Windows NT If you have reinstalled Windows NT, next you will need to install device drivers to support the notebook hardware components. (The video, audio, and touchpad are not functional after reinstalling Windows. ) Also, you will need to install Card Wizard software for controlling the PC Card slots and Power Profiler software for power management. To make these components and software functional, use the procedures discussed in this section to load the following drivers and software: o o o o o Video Audio Card Wizard and Power Profiler Windows NT Service Pack 3 Mouse (EZ Pad Plus) If you have not reinstalled Windows NT, but are experiencing difficulty with a specific hardware device(s) such as video, sound or others, then try reinstalling the device driver by using the procedures in this section. Windows NT display drivers When Windows NT is installed on a newly formatted hard drive it detects the display as a Standard PCI Graphics Adapter. Use the following instructions to install the Windows NT display drivers that optimize your Solo display. If the Solo System CD shipped with your system, you may use it to install the driver instead of installing the drivers from diskette. Installing the Solo 5100 Chips and Technologies video driver 1. [. . . ] A message appears that reads "Warning the CMOS checksum is invalid. Default values will be loaded. " Then press <Enter> to go to the Exit menu and choose Save the changes and exit. To check the space left on the disk or diskette click Start button, click Programs, click Windows Explore. To create more storage space, delete the unnecessary files you no longer need. [. . . ]